Q-See QSDT4PCRC Manual de servicio Pagina 38

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 54
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 37
74 75
CHAPTER 9
REMOTE SURVEILLANCE & PLAYBACK
STORAGE DISK
You can choose where to store recorded files by selecting storage disk. By checking the
Recycle check box, users can setup the software to continue recording after the hard drive is
full by recording over the oldest files on the hard drive.
PICTURE 9-58
PICTURE 9-59
PICTURE 9-60
PICTURE 9-61
By clicking Copy To you can copy the setting
of this channel to any other selected channel.
MOTION CONFIGURATION
Click the running figure icon to access the Motion Configuration interface.
Sensitivity - Set motion detection sensitivity
here.
Speed - Motion detection speed
Block number - Set grid’s number
Select all - Select all the areas of the channel
as detection area
Clear all - Clear all the detection areas
and then users can select customized
detection areas using mouse curser.
By clicking Copy To you can copy the setting of this channel to any other selected channel.
E-MAIL CONFIGURATION
Click the E-mail icon to access to E-mail Configuration interface.
Mail server setup
In this area, users can set receiver and
sender’s E-mail SMTP server and address.
Note: the address of receiver and sender can
be the same.
SMTP server - Sender’s SMTP, such as
smtp.yahoo.com
User name - Sender’s User Name
SMTP PORT - Mail server’s port, the default
value of mail server is 25.
Password - Sender’s Password
You can select ‘My server requires a secure
connections’ or ‘My outgoing server
(SMTP)requires authentication’ check box
according to server mail service policy of mail
service provider.
Mail setup
Send to - Receiver’s E-mail Address
E-Mail from - Sender’s E-mail Address
Subject - E-mail Subject
You can select the ‘Set Mail Internal’ check
box to set e-mail send time, such as 5
seconds, 10 seconds and so on.
PICTURE 9-62
PICTURE 9-63
Attachment setup
Select ‘Attachment’ and the system will attach an image from the camera that triggered the
alarm to the designated recipient.
Camera - Channel Name
Time - Display Time
Format - Image Format
Resolution - CIF or QCIF
Vista de pagina 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 53 54

Comentarios a estos manuales

Sin comentarios