Q-See QSDT8DP Manual de usuario descargar pdf (Pagina 38)

QSDT8DP DVR User’s Manual

Here users can set sensor type, alarm trigger and alarm time. The following

are the definitions of each option.

Device type: NC and NO (Normal Close and Normal Open). Set the value

according to the alarm signal level of the sensors.

Enable: Enable sensor alarm.

Trigger: Set alarm output, recording channel and speed dome linking. Click

Set button, a window will appear shown as Fig 4.10 Alarm Out Configuration.

Fig 4.10 Alarm Out Configuration

Alarm out: Set relay alarm out channel. You can select any alarm

channels.

To record: Set recording channels. You can select any record channels. It

will record on the cameras you choose here when alarm triggered.

Buzzer: Enable on board buzzer for alarm.

To P.T.Z CH: Set linked preset and cruise for alarm. You can select any

channel and multi channels as linked channels.

Alarm in hold time(S): The interval time between two consecutive sensor

alarm events. If a second alarm is detected within Hold time, it is recognized

as a continuous alarm. If a second alarm is detected after hold time, the

second alarm and the previous one are recognized as two different alarm

events.

Alarm out hold time(S): Set relay alarm out time after alarm is triggered.

Buzzer hold time(S): set on board buzzer time after alarm is triggered.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 79 80

Sin comentarios

Q-See QSDT8DP Manual de usuario Pagina 38