Q-See QSIPO26X Manual de servicio descargar pdf (Pagina 16)

Open the hinged door to the back box.

Pull power cable, video cable, RS485 cable, network cable through cable feed out of

the conduit fittings. Connect them with PCB board.

Close the hinged door and screw the bolts.

Pushing the back box into the installation hole (you just cut in step 1) by

compressing the tab lock.

Tighten the screws in the black tab locks to fix the back box in the ceiling.

Note: please install a safety chain/cable (not supplied) between the back box and the

ceiling to prevent network speed dome falling down!

Step 3

Install the dome drive.

Before installation, please take out the protective

foam and put it in a well place for future use.

Note: when you ship the network speed dome to the

manufacturer, please insert these foams to

protect the drive.

Line up the red (A) and red (B) tabs with the red

(A) and red (B) labels in the interior back box.

Push in (B) side and then the other side.

Continue pushing on the ends of the tabs until

you hear a click noise.

Steel safety c

able

Red tab

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 64 65

Sin comentarios

Q-See QSIPO26X Manual de servicio Pagina 16