Q-See QT474 Manual de usuario descargar pdf (Pagina 11)

20 21

SYSTEM CONFIGURATION

CHAPTER 4

In addition to adding DVRs to CMS as covered in Chapter 2, System Conﬁguration gives

you access to conﬁgure how your computer uses and saves video, manage who has access

to CMS, as well as adding or removing monitored systems.

Enter the System Conﬁguration mode by

clicking on the System Conﬁg button at the

lower right of your screen.

This will take you back to the Control

Center window which you used to add

systems to monitor.

4.1 DEVICE MANAGER

By default, this window will open up in the Device Manager mode allowing you to add, remove

or modify systems. This was covered in Section 2.4 Basic Configuration. The Alarm

Display will continue to operate underneath the main display.

4.2 LOCAL CONFIGURATION

This area allows you to change how CMS interacts with the computer you are using. These

settings only apply to that speciﬁc computer and do not alter any of the settings on any of the

DVRs being monitored, nor do they change any other computers that you use to run CMS.

There are three tabs in this window: Local Basic Conﬁguration, Local Schedule

Conﬁguration and Local Alarm Conﬁguration.

LOCAL BASIC CONFIGURATION

In this tab, you can control aspects such as where video is recorded on your computer, how

alarms are handled and whether you want your PC to auto restart among other settings.

Dwell Time

This is differs from the Dwell Time setting available in the Device Manager (Section 2.4

Basic Configuration). Instead of switching between groups of cameras, this will only switch

between full-screen views from a single DVR. You cannot have Group Dwell active at the

same time.

In Title, you can chose whether the on-screen display shows the DVRs name as well as the

channel, just the channel or no additional title. This information could overlay similar displays

presented by the DVR.

Snap picture number - this allows you to determine the number of snapshots taken when

using the Snapshot button (see Snapshot in the previous chapter). This can be

overridden in the Snapshot dialogue box, but it will remain the default setting for future uses.

Meijer.com

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Sin comentarios

Q-See QT474 Manual de usuario Pagina 11