Q-See QSC26416 Manual de usuario descargar pdf (Pagina 83)

User Manual for Commercial Series Net DVR

Page 83 Total 121

6.15 PTZ

There is one RS-485 port at DVR rear panel used for PTZ control. You can setup RS-485

parameters to match your PTZ protocol. In main menu, move “Active Frame” to PTZ icon and

press【ENTER】key, you can enter into PTZ menu as follows:

PTZ menu description

Select channel: Select one PTZ camera.

RS-485 parameters: Including baudrate, data bit, stop bit, parity, flow control, etc. These

parameters must be the same as those of PTZ. Protocol.

PTZ address: Each PTZ has one different address.

PTZ type: DVR supports the following PTZ protocols: YouLi, LinLin-1016, LinLin-820,

Pelco-p, DM DynaColor, HD600, JC-4116, Pelco-d WX, Pelco-D, VCOM VC-2000, NetStreamer,

SAE/YAAN, Samsung, Kalatel-312, CELOTEX, TLPelco-p, TLHHX-2000, BBV, RM110,

KC3360S, ACES, ALSON, INV3609HD, Howell, Tc Pelco P, Tc Pelco D, AUTO-M, AUTO-H,

ANTEN, CHANGLIN, DeltaDome, XYM-12, ADR8060, EVI-D30, DEMO-SPEED,

DM-PELCO-D, ST832, LC-D2104, HUNTER, A01, TECHYIN, WEIHAN, LG, D-MAX,

Panasonic, KTD-348, infinova, PIH-7625, LCU, DennarDome, etc. Other PTZ protocols may be

added through new firmware.

Note: In DVR “PTZ” menu, if you select Pelco-P protocol, when you setup PTZ address,

please use 1 number higher or lower then the Camera ID. For example, if camera ID is 2, the DVR

PTZ address is set as ID 3.

Preset setup: Preset is using one number to represent the camera’s position, zoom, focus and

iris. Move “Active Frame” to “Setup” button on the right side of “Preset” item, press【ENTER】

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 120 121

Sin comentarios

Q-See QSC26416 Manual de usuario Pagina 83