Q-See QS434 Manual de usuario descargar pdf (Pagina 36)

DEVICE OPERATION Model #: QS434

29 | Page

To configure alarm settings (Figure 3.5.28):

1) Under I/O CHANNEL, select NO (Normal Open), NC (Normal Closed), or OFF. Click NEXT PAGE to view

additional channels (8-channel models only).

2) Apply loss alarms to the following:

• HDD LOSS: The alarm will sound if the internal hard drive is damaged

• HDD SPACE: The alarm will sound when the hard drive is full (if overwrite is disabled)

• VIDEO LOSS: The alarm will sound when a camera is disconnected

3) Under ALARM MANAGE, configure the following:

• OUTPUT: Set the output time (in seconds) on the spot monitor from 0s, 10s, 20s, 40s, or 60s.

• BUZZER: Set the time (in seconds) for the buzzer when an alarm is triggered—0s, 10s, 20s, 40s, or 60s

NOTE: Set the buzzer to 0s if you want to disable the alarm during motion detection

• POST REC: Set the time (in seconds) for the system to record after a triggered alarm—0s, 10s, 20s, 40s, or

60s

4) Click APPLY. Click CLOSE in the confirmation window.

EMAIL SETUP：

The system can send an email notification with a JPEG snapshot for triggered events on the system.

Figure 3.5.29

To setup email notification (Figure 3.5.29):

1) Under EMAIL, select ON.

2) Under SSL, select OFF.

NOTE: SSL deals with encryption. Only advanced users should enable this option.

3) Under SMTP PORT, enter the SMTP port of your email server.

4) Under SMTP, enter the SMTP address of your email server. For example, smtp.gmail.com

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 66 67

Sin comentarios

Q-See QS434 Manual de usuario Pagina 36