Q-See QS434 Manual de usuario descargar pdf (Pagina 66)

TROUBLESHOOTING Model #: QS434

59 | Page

7. TROUBLESHOOTING

Error

Possible Causes

Solutions

• System is not receiving

power or is not powering

• Cable from power adapter is

loose or unplugged.

• Confirm that all cables are connected correctly

• Confirm that the power adapter is securely connected

to the back of the unit

• Cables are connected but

system is not receiving

sufficient power

•

Confirm that the system is powered on (LED indicators

on the front should be ON)

• If the unit is connected through a power bar or surge

protector. Try bypassing the bar and connecting the

power directly to the wall outlet

•

Plug another electrical device in the outlet to verify that

the outlet is receiving power.

• Connect the system power cable to another outlet.

• Remote control is not

detected by the system

• Battery in the remote control is

drained

• Install two fresh AAA alkaline batteries in the remote

control

• There are no batteries in the

remote control

• Hard drive is not detected

by the system

• Hard drive cables are loose or

not properly connected

• Remove the housi

ng and ensure hard drive cables are

firmly connected

• There is no hard drive in the

system

• Open the housing and install a 3.5” SATA hard drive

•

Hard drive is full (0%) and

the unit is no longer

recording

• Overwrite is not enabled • From the Main Menu: select HDD>Overwrite>Enable

and Apply

• Mouse not detected by

system

• Mouse cable is not firmly

connected to the system

• Firmly connect the mouse cable to the USB Mouse

port on the front panel

• Mouse is not connected to the

system

• System needs to be reset • Turn the power to the system off (disconnect power

cable). Firmly connect a USB mouse to the USB

mouse port on the front panel of the system.

Reconnect the power cable to the DC 19V port on the

rear panel.

• There is no picture on

selected channels/camera

picture is not being

displayed

• Camera cables are loose or

have been disconnected

• Check the camera video cable and connections

•

Disconnect and reconnect the cable at the system and

at the camera

• Try moving the camera to another channel or use

another cable

1 2 ... 61 62 63 64 65 66 67

Comentarios a estos manuales

Sin comentarios

Q-See QS434 Manual de usuario Pagina 66

Comentarios a estos manuales

Relacionado con productos y manuales para Grabadores de vídeo digital (dvr) Q-See QS434