Q-See QT528 Manual de usuario descargar pdf (Pagina 11)

20 21

CHAPTER 4 MAIN MENU SETUP

PICTURE 4-20

PICTURE 4-21

PICTURE 4-22

PICTURE 4-23

4.4 SCHEDULE CONFIGURATION

Conﬁgure your camera to record at speciﬁc times based on time of day, motion detection or

other sensor input. There are three tabs; Schedule, Motion and Sensor

Schedule Tab

The schedule for automatic recording can be set either of two ways.

1. By highlighting individual hours for speciﬁc

days by using the pencil tool in the upper

right of the window. The adjacent eraser

tool removes the highlighting in a block.

Double click on either the pencil or eraser

tool to turn them off. Settings can be

copied and applied to any or all of the

channels and to any other day.

2. Blocks of time to be recorded can also

be set up by double clicking on a ﬁeld

adjacent to a day. Multiple schedules can

be created and saved with start and stop

times down to the minute. These can then

be applied to multiple days and cameras.

Schedules made in one mode can be altered in the other mode.

Motion Tab

Motion detected during the highlighted hours will cause the DVR to start recording. Setup is

similar to that used in Schedule above. The default mode is for 24/7.

Sensor Tab

This enables the DVR to record based on input from other sensors connected to the DVR. Like

motion detection, it is default scheduled to be able to record at any time. It is also conﬁgured

in the same manner as explained under Schedule.

PICTURE 4-24

PICTURE 4-25

PICTURE 4-26

4.5 ALARM CONFIGURATION

Alarm conﬁguration allows the DVR to begin recording based on input from other remote

sensors such as infrared motion detectors or contact alarms which are connected to it.

There are ﬁve submenus; Sensor, Motion, Video Loss, Other, and Alarm Out.

SENSOR

In this window you can setup optional external sensors to cause the DVR to begin recording.

There are three tabs in this window: Basic, Alarm Handling and Schedule.

Basic Tab

This allows you to enable the input from

attached sensors. You can also identify the

sensors by name for ease in determining

location.

Set the alarm type according to whether the

alarm is NO (Normally Open) or NC (Normally

Closed). See your alarm’s manual for details.

Alarms can be individually conﬁgured or

globally set using the All button.

Alarm Handling Tab

Conﬁgure how you want the DVR to handle

the input from an activated alarm. Each

sensor input can be set to launch individual

sequences of action or they may be globally

set through the All button to have the same

results.

Hold Time: determines the time allowed

between consecutive alarm events.

If the alarm is triggered again within

this time, it will be treated as a single

event and the DVR will continue

recording before stopping – unless,

of course, a subsequent alarm is

activated within the hold time.

Trigger: This is what the DVR will do once

activated by an alarm. Selecting

Setting will open a new window with

three tabs; Alarm, To Record, To

PTZ

Alarm allows you to set whether a

buzzer will sound, which camera (if

any) will display in full screen mode,

whether an e-mail will be sent and

whether a signal will be sent via the

ALARM OUT port.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 49 50

Comentarios a estos manuales

Sin comentarios

Q-See QT528 Manual de usuario Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Grabadores de vídeo digital (dvr) Q-See QT528