Q-See QT528 Manual de usuario descargar pdf (Pagina 26)

50 51

CHAPTER 7 REMOTE SURVEILLANCE

7.4 DDNS (DYNAMIC DOMAIN NAME SERVICE)

You can access the DVR over the Internet using a static or dynamic IP address. However, your

service provider can change this dynamic address from time to time. When it changes, you

will have to return to www.MyIPAaddress.com, again from a computer attached to the same

router as the DVR to get the new public IP address.

There are two solutions to this problem. The ﬁrst would be to obtain a static IP address from

your ISP – which can be expensive. A second – and free – option is to use a dynamic domain

name service (DDNS) to get a domain name that can be linked to your dynamic IP address. In

addition to automatically keeping up with the changes in the address, you will now be able to

enter a domain name rather than a string of digits when accessing the DVR in Internet Explorer.

While there are multiple free DDNS services available, we recommend using www.MyQ-See.

com or www.DynDNS.com as the DVR has been already conﬁgured to accept account

information from these two services.

NOTE! Before setting up DDNS, you must have previously set up Port

Forwarding as described in the previous section.

Setting up DDNS

The following instructions are for setting up DDNS with MyQ-See, instructions for DynDNS are

available on their website.

STEP 1. Using a computer that is

connected to the same router as the

DVR, use Internet Explorer to go to

www.MyQ-See.com

STEP 2. Click on the “New User?” link at

the bottom of the page (http://MyQ-

See.com/reg.asp)

STEP 3. Complete the registration

process by following the on-screen

directions and click the Submit

button at the bottom of the screen.

STEP 4. You will now be asked to create

a domain name. Domain names must

begin with a letter (a-z) or a number

(0-9) and cannot contain a hyphen.

Once you’ve decided upon a name,

click on the “Request Domain”

button. If it is available you will see a

conﬁrmation screen along with the IP

address associated with it. Conﬁrm

that this matches the number shown

at www.MyIPAaddress.com Your

domain name will look like this:

http://example.myq-see.com

PICTURE 7-19

PICTURE 7-20

STEP 5. Once you have obtained your domain name, you will need to conﬁgure the DVR

for access using it.

To set up the DVR for access through a dynamic domain name:

STEP 1. Go to the Main Menu and

select the Setup icon (Red box in

Figure 7.21)

STEP 2. Select the Network icon (Red

box in Picture 7.22)

STEP 3. Select DDNS (Red box in

Picture 7.23)

STEP 4. Select the service – MyQ-See or

DynDNS you are using and enter the

account information you registered

with the domain name service.

STEP 5. Click the Test button

STEP 6. After receiving the OK message

in the lower left corner of the screen,

click on the Apply button to save

your settings.

You are now able to access the DVR remotely over the Internet by entering the domain name

into a browser window.

PICTURE 7-21

PICTURE 7-22

PICTURE 7-23

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 49 50

Comentarios a estos manuales

Sin comentarios

Q-See QT528 Manual de usuario Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Grabadores de vídeo digital (dvr) Q-See QT528